Safety regulations for operating coating equipment

Many new users do not know how to correctly operate the vacuum coating equipment; Under the normal operation of the machine tool, when the vacuum coating equipment starts the machine, you should first open the water pipe and always pay attention to the working water pressure. At the same time, for ion bombardment and evaporation, special attention should be paid to high-voltage wire connectors, which should not be contacted to prevent electric shock. The coating in the electron gun, on the aluminum peripheral bell. When using lead glass to observe the window glass, you should wear glasses to observe the lead glass, so as to prevent X-ray from affecting the human body. For the deposition of multi-layer medium film coating, the vacuum coating equipment should be installed with ventilation and dust removal equipment to remove harmful dust in time. Keep flammable and toxic substances poisoned in fire.

The pickling device shall be carried out on the ventilation device and rubber gloves shall be worn. The acid or alkali of the parts into the cleaning tank shall be gentle, and the vacuum coating equipment shall be free from collision and splash. In addition, the commonly used pickling basin shall be covered. After this work is completed, the water shall be cut off.

What safety specifications should be paid attention to: the use of vacuum system, vacuum system, high-temperature vacuum pump and oil filling system, and the vacuum coating equipment are slightly exposed to the risk of accidental explosion and combustion. Therefore, in the process of work, the installation and operation specifications should be strictly followed. Be careful. Heat pump scalding is dangerous, and rotating parts may harm people. Therefore, attention should be paid to the inaccessible booster pump and diffusion pump in the production process, The pre operation shields of the slide valve pump and the Roots pump should be complete and inaccessible. The equipment winding system of the vacuum coating equipment may be dangerous to hurt people during operation. Therefore, the speed of the vacuum coating equipment in the rear masking and cleaning roll cannot be too fast, not more than 30 m/min.